Popular Articles
Ender 6 User Man
V1.3 V轮松紧度调节 Before starting up, please check the tightness of the V wheel. V wheel leveling X/Y axis V wheel adjustment: Z轴V轮调节: X/Y轴V轮调节: Z axis V wheel adjustment: Adjustable eccentric isolation column Notes 笔记 18F www.cxsw3d.com 服务热线:400 6133 882 ...
How To Calibrate the Extruder Steps (Ender-3 / Ender-5 / CR-10)
When our 3D prints are less than perfect, the Extruder Steps (or e-steps) are often checked as a last resort. There are plenty of other tweaks that can improve results, but e-steps should be the first suspect on every new 3D Printer. It’s responsible ...
Not all overhangs need supports - the 45 degrees rule
Not all overhangs need to be supported. The general rule of thumb is: if an overhang tilts at an angle less than 45 degrees from the vertical, then you may be able to print that overhang without using 3D printing support structures. 3D printers use a ...
Not all bridges require support – the 5 mm rule
Just like overhangs, not all bridges require support. Here, the rule of thumb is: If a bridge is less than 5 mm in length, the printer may be able to print it without requiring 3D printing support structures. To do this, the printer uses a technique ...
Chamfers and Supports
Another way to eliminate the need for 3D printing support structures is Chamfers. Chamfers are a neat way of turning otherwise nasty overhangs into innocuous overhangs with angles less than 45 degrees. For example, if you have a gently sloping or ...